Cover Image

Numerical simulation of Effect of Contact Pressure on Mechanical Behavior of Gas Diffusion Layers (GDL) and PFSA Membrane Assembly

Mohamed Karim Ettouhami, Adil Atifi, Hamid Mounir, Yassine Amadane

Abstract


In this study, a Finite Element model has been implemented based on numerical modelling simulations to predict the mechanical behaviour of a representative unit of the fuel cell stack. The GDL deformation has been modelled as a combination of elastic deformation and fibres slippage. Mechanical stresses distribution and deformation are presented concerning the previous model work l with nonlinear orthotropic behaviour of the GDL. The results also show that the state of the stresses in the membrane are highly heterogeneous and largely exceed its elastic limit. The results show that the influence of the temperature variation is not significant in generating stresses. However, the influence of the moisture variation is very significant in generating stresses. Therefore, the increase in relative humidity from 30% to 90° % at T=25°C causes an increase in the maximum Von Mises stress of 0.0836MPa.

Full Text:

PDF

References


- Y. Faydi, R. Lachat, Y. Meyer, Thermomechanical characterization of commercial Gas Diffusion Layers of a Proton Exchange Membrane Fuel Cell for high compressive pre-load sunder dynamic excitation Fuel. Journal of Power Sources, 2016, 182, 124-130.

- Z. Zhang, Mechanical contact analysis on the interfaces in a proton exchange membrane fuel cell. Mécanique & Industries, 2010, 11(3-4),

-188.

- S. Escribano, J. Blachot, J. Ethève, A. Morin, Modal Characterization of PEMFCS gas diffusion layers' properties. J. Power Sources, 2006, 156, 8-13.

- S. D. Yim, B. J. Kim, Y. J. Sohn, Y. G. Yoon,

G. Park, W. Y. Lee, The influences of stack clamping pressure on the performance of PEM fuel cell stack. Curr Apply Phys., 2010, 59-61.

- Y. Zhou, G. Lin, A. Shih, and Hu S J. Multi-physics modeling of assembly pressure effects on PEM fuel cell performance, ASME. Journal of Fuel Cell Science and Technology, 2008.

- Y. Zhou, G. Lin, A. Shih, S.J. Hu, Assembly pressure and membrane swelling in PEM fuel cells. Journal of Power Sources, 2009, 192,

-51.

- J. L. Shuo, D. H. Chen, Ching-Han Huang, Analyses of the fuel cell stack assembly pressure. J. of Power Sources, 145, 2005, 353-361.

- G.Jiabin, H. Andrew, L. Hongtan, Effect of gas diffusion layer compression on PEM fuel cell performance. Journal of Power Sources, 2006, 159, 922-927.

- R. Montanini, G. Squadrito, G. Giacoppo, Realization of uniform internal stress distribution for each cell component is therefore essential. XIX IMEKO World Congress Fundamental and Applied Metrology, September 2009, 6-11.

- T. T. Chin, T. Lin, H. R. Shiur, The Effect of Clamping Pressure on Gas Diffusion Layer Performance in Polymer Electrolyte Fuel Cells. Journal of the Chinese Institute of Engineers. Journal of the Chinese Institute of Engineers, 2016, 39, 353-362.

- L. Peng, Q. Diankai, Y. Peiyun, L. Ximin, Dimensional Error of Stamped Bipolar Plate and Gas Diffusion Layer in Proton Exchange Membrane Fuel Cell Stack Assembly. Journal of Electrochemical Energy Conversion and Storage, 2016, Vol. / 02,107-113.

- A. El-Kharouf, W. R. Steinberger, The Effect of Clamping Pressure on Gas Diffusion Layer Performance in Polymer Electrolyte Fuel Cells. 2016.

- Y. Zhou, C. Liu, J. Liang, L. Wang, Investigation of the effects of compression pressure on the direct methanol fuel cell. Power Sources, 2011, 9, 196-264.

- G. Maranzana, O. Lottin, T. Colinart, S. Chupin, S. Didier jean, A multi instrumented polymer exchange membrane fuel cell: Observation of the in-plane non-homogeneities. Journal of Power Sources, 2008, Vol. 180, N°2, 748-754

- S. Basu, J. Li, C Y. Wang, Two-phase flow and maldistribution in gas channels of a polymer electrolyte fuel cell. Journal of Power Sources, 2009, 187, 431-443.

- S. Haase, M. Rauber, Ex-situ gas diffusion layer intrusion effect determination of polymer electrolyte membrane fuel cell flow fields. 2015, 5-35.

- S.G. Kandlikar, Z. Lu, TY. Lin, D. Cooke, M. Daino, Uneven gas diffusion layer intrusion in gas channel arrays of proton exchange membrane fuel cell and its effects on flow distribution. Power Sources, 2009, 194-328.

- K. C. Neyerlin, H. A. Gasteiger, C. K. Mittelsteadt, J. Jorne, W. Gu, Effect of relative humidity on oxygen reduction kinetics in a PEMFC. J Electrochem Soc 2005, 152,

A1073-1080.

- A. Turhan, K. Heller, J.S. Brenizer, M.M. Mench, Quantification of liquid water accumulation and distribution in a polymer electrolyte fuel cell using neutron imaging. J Power Sources, 2006, 160, 1195-203.

- R. L. Borup, J. R. Davey, F. H. Garzon, D. L. Wood, M.A. Inbody, PEM fuel cell electrocatalyst durability measurements. J Power Sources, 2006, 163, 76-81.

- J. Zhang, Y. Tang, C. Song, Z. Xia, H. Li, H. Wang, PEM fuel cell relative humidity (RH) and its effect on performance at high temperature. Electrochim Acta, 2008, 53,

-5321.

- W. Bi, Q. Sun, Y. Deng, TF. Fuller, The effect of humidity and oxygen partial pressure on the degradation of Pt/C catalyst in PEM fuel cell. Electrochim Acta, 2009, 54, 1826-33.

- K.H. Lim, H.S. Oh, S.E. Jang, Y.J. Ko, H.J. Kim, H. Kim, Effect of operating conditions on carbon corrosion in polymer electrolyte membrane fuel cells. J Power Sources, 2009, 193, 575-9.

- K. Shinozaki, H. Yamada, Y. Morimoto, Relative humidity dependence of Pt utilization in polymer electrolyte fuel cell electrodes: effects of electrode thickness, ionomer-to-carbon ratio, ionomer equivalent weight, and carbon support. J Electrochem Soc, 2011, 158, B467-75.

- L. Xing, M. Mamlouk, R. Kumar, K. Scott, Numerical investigation of the optimal Nafion ionomer content in cathode catalyst layer: an agglomerate two-phase flow modelling. Int J Hydrogen Energy 2014, 39, 9087-9104.

- L. Xing, PK. Das, X. Song, M. Mamlouk, K. Scott, Numerical analysis of the optimum membrane/ionomer water content of PEMFCs: the interaction of Nafion ionomer content and cathode relative humidity. Appl Energy, 2015, 138, 242-257.

- L. Xing, Q. Cai, C. Xu, C. Liu, K. Scott, Y. Yan, Numerical study of the effect of relative humidity and stoichiome-tric flow ratio on PEM (proton exchange membrane) fuel cell performance with various channel lengths: An anode partial flooding modelling, Energy, 2016, 106, 631-645.

- A. Pablo, G. Salaberri, M. Vera, R. Zaera, Nonlinear orthotropic model of the inhomogeneous assembly compression of PEM fuel cell gas diffusion layers, International Journal of Hydrogen Energy, 36, 2011,

-11870.

- J. Kleemann, F. Finsterwalder, W. Tillmetz, Characterization of mechanical behavior and couple electrical properties of polymer electrolyte membrane fuel cell gas diffusion layers. Journal of Power Sources, 190, 2009, 92-102.

- E. Firat, P. Beckhaus, A. Heinzel, Finite Element Approach for the Analysis of the Fuel Cell Internal Stress Distribution. Proceeding of the COMSOL conference of Stuttgart, 2011.

- O. Kyeongmin, C. Purushothama, J. Hyunchul, Numerical study of thermal stresses in high temperature proton exchange membrane fuel cell (HT-PEMFC). International journal of hydrogen energy39, 2014, 2785-2794.

- Y. Tang, A. Karlsson, M. Santare, M. Gilbert, S. Cleghorn, W. Johnson, An experimental investigation of humidity and temperature effects on the mechanical properties of perfluorosulfonic acid membrane. J. Mater. Sci., 2006, 425,

-304.

- E. Sadeghi, N. Djilali, M. Bahrami, Effective thermal conductivity and thermal contact resistance of gas diffusion layers in proton exchange membrane fuel cells. Journal of Power Sources, 2011, 196, 246-254.

- A. Kusoglu, A. M. Karlsson, M. Santare,

S. Cleghorn, W. B. Johnson, Mechanical response of fuel cell membranes subjected to a hygro thermal cycle. J Power Sources, 2006, 161, 987-996.

- D. Bograchev, M. J. Gueguen, S. Grandidier,

S. Martemianov, Stress and plastic deformation of MEA in fuel cell Stresses generated during cell assembly. Journal of Power sources, 2008, 180, 393-401.




DOI: http://dx.doi.org/10.13171/mjc8619071811emk

Refbacks

  • There are currently no refbacks.


Copyright (c) 2019 Mediterranean Journal of Chemistry